measuring your ring size
You can upload and print our free ring sizer or use the directions below!
Measure with a string
1. Take a string and wrap is around the base of your finger.
2. Make sure it’s snug but not tight (should slide over your knuckle).
3. Use a pen to mark where the end of the string overlaps itself around your finger.
4. Lay the string flat and measure from the start of the string to the marked point using a ruler (measure in mm).
5. Use the total length of your string (in millimeters) to find your ring size - size are on downloadable pdf in link above!
Measure your bracelet size
1. Use a cord, a ribbon, or a piece of paper and wrap one of these options around your wrist
2. Put a mark at the end where the material overlaps.
3. You can then measure the cord or the ribbon with a ruler. This will give you a measurement as precise as possible from home to determine whether a bracelet size works for you.
*Our bracelets typically fit on wrist sizes 6-8 inches.
measure your necklace size
Necklace lengths can look and fit a little differently on each person. If you don't know your preferred necklace length, follow the directions below. As you measure, you can play with the lengths to see which is your favorite length!
1. You'll need a piece of string and a ruler or measuring tape.
2. Find your preferred length by wrapping the string around your neck and marking the desired length (use a pen or marker to mark where the string overlaps).
3. Check the length by holding the string up against your ruler or measuring tape and reading where you had marked the string with the pen or marker (make sure the beginning of the string starts on zero!)
OR….
If you love the length of a necklace you already own, use a ruler or tape measure to measure the length of your chain.